The steps below are for setting up your CloudMail email account inside Microsoft Outlook 2010 using POP.

1. In Microsoft Outlook, click the File tab, and select Info on the left.

2. On the Account Information page, click the Account Settings button, and select Account Settings from the drop-down menu.

3. In the Account Settings window on the E-mail tab, click New.

4. On the next page in the Add New Account window, do not enter any information, and select the Manually configure server settings or additional server types option, and then click Next.

5. Click Internet E-mail, and then click Next.

6. On the Internet E-Mail Settings window, enter the following information:

7. Leave Log on using Secure Password Authentication (SPA) unchecked.

8. Click More Settings.

9. In the Internet E-mail Settings window, go to the Outgoing Server tab.

10. Select My outgoing server (SMTP) requires authentication.

11. Select Use same settings as my incoming mail server.

12. Go to the Advanced tab, and change the Outgoing server (SMTP) port to 587.

13. Click OK.

14. Click the Test Account Settings button under Test Settings. If everything is setup properly, all tests should run successfully and pass.

15. If the tests run fine, then click Next.

16. Click Finish.

NOTE: As a courtesy, we provide information about how to use certain third-party products, but we do not endorse or directly support third-party products and we are not responsible for the functions or reliability of such products. We are not affiliated with, endorsed, or sponsored by Microsoft or Microsoft Products. Outlook 2010® is a registered trademark of Microsoft Corporation in the United States and/or other countries. All rights reserved.